Best Protection
Complete removal of fire hazard from hot carbon sparks is
achieved with the effective HAPCO Spark
Arrestor.
All dangerous carbon sparks are trapped as they emerge from
the engine of any equipment by a
centrifugal motion set up in the exhaust stream, which
separates carbon particles from the exhaust
gases. These particles are caught in an easily serviced
receptacle. The exterior of all Spark Arrestors is protected
with a high-heat aluminum silicone base paint, which
withstands severe atmospheric conditions and temperature up
to 1200 degree F.Mostly widely accepted
The HAPCO Spark Arrestor has been tested and qualified by
the U.S. Forest Service. The U.S. Air Force
uses HAPCO on their own equipment. This acceptance plus
approval by the Pacific Fire Rating Bureau
assures you that all installations with HAPCO Spark
Arrestors will be approved by State and Federal
Equipment Inspectors.
Most Practical Design
The small, compact design of the HAPCO Spark Arrestor unit
permits lowest installation on your
equipment, safeguarding it against knocks and damage from
limbs or other objects. A weatherstop is
included with every spark arrestor.
HAPCO is a light, balanced weight type structure, available
in a full range of stack sizes. It is manufactured
in both mild steel and in all stainless steel. Power output
is not reduced with high back pressure as is
the case with screens and most other arrestors.
HAPCO is a light, balanced weight type structure, available
in a full range of stack sizes. It is manufactured
in both mild steel and in all stainless steel. Power output
is not reduced with high back pressure as is
the case with screens and most other arrestors.
|
